Rotisserie Ventless Hood | Installation |
Wiring
Electrocution, equipment failure or property damage could result if an unlicensed electrician performs the electrical installation. Ensure that a licensed electrician perform the electrical installation.
In the event of an appliance fire, serious injury, property damage or death could occur if the appliance is powered from a source other than the oven. The hood MUST receive its input power from the rotisserie for which it is mounted on.
1.Feed power wires and interlock wires through access hole into VGG.
2.The power wires # 14, 15, and ground are wired as follows:
3 phase, 3 wire
3 phase, 4 wire
3.For interlock, remove #5 wire from VGG Power Switch. Crimp male connector provided with VGH onto #5 wire and plug into female connector of VGH wire #11. Place VGH wire #10 into VGG Power Switch where #5 wire was.
4.Replace all side panels.
7
