Baldor PC32RI, PC43RI manual Section Operation

Section 4

Operation

Operator Control Panel

The Operator Control Panel is shown in Figure 4-1.

Figure 4-1 Operator Control Panel

Oil Level	Auto Power Save Switch
Lamp
Multi Monitor Display		Units LED’s

~ AC OUTPUT

Units

Select

Switch

STOP		NEMA 5−20R	DC
	STOP		Breaker
ON		ON
		START
	CHOKE	−	− +

NEMA L530R

+

BATTERY CHARGE ONLY

DC 12V − 8.3A

Auto	Engine	Key	(−) Battery Charger	(+) Battery Charger	Ground
P−Save LED	Switch	Switch	Connection	Connection	Terminal
Multi Monitor Display		A five digit display for messages or display of Hours, Volts or Hertz.
Overload Display		“O_LOD” is displayed on the Multi Monitor display when generator is running and an
		overload condition exists. To reset, Stop the generator and Start the generator again to
		resume operation.
Units LED’s		When Units Select Switch is set to Hours, Units Hours LED is ON and
			operating hours is displayed on Multi Monitor Display.
		When Units Select Switch is set to V, Units V LED is ON and
			Generator Output Volts is displayed on Multi Monitor Display.
		When Units Select Switch is set to Hz, Units Hz LED is ON and
			Generator Output Frequency is displayed on Multi Monitor Display.
Units Select Switch		Pressing	Switch changes display modes from Hours, Volts and Hz.
Oil Level Lamp		Lamp is on when engine oil level is less than a predetermined level. When the lamp
		turns ON, the engine will stop automatically. If Oil Lamp is ON, replenish the engine oil
		level and restart the engine.

Auto Power Save Switch Press to select Power Save Mode, (Auto P−Save LED is ON) and generator speed changes for the applied load. Output voltage and frequency remain constant even at engine idle speed.

Press again to deselect Power Save mode and generator runs at full speed and produces full power. Use this mode (Auto P−Save LED is OFF) for DC power.

Auto P−Save LED	OFF when generator runs at full speed and produces full power.
	ON when generator is in Power Save Mode (Adjustable Speed).
Engine Switch	Stop	In this position, the engine is stopped and fuel supply line is closed.
	Run	Allows the engine to start and run during normal operation.
	Choke	Allows cold weather starting, place the Engine Switch in the Run position
		after engine is started.
Key Switch	Stop	In this position, the engine is stopped.
	ON	Engine run position after starting.
	Start	Engine start position, engages engine starter to crank the engine.

MN2403 Operation 4-1