![](/images/new-backgrounds/1030517/305177x1.webp)
Set up the loudspeaker – cable connections
The loudspeaker socket panel is located on the rear. Insert the cables and set the POSITION switch before you fasten the loudspeaker to the wall bracket.
For information about the sockets on the Bang & Olufsen system, refer to the Guides enclosed with the product.
Before you make any connections, disconnect your Bang & Olufsen system from the mains supply!
POWER LINK socket
Cable clamp
POSITION switch
Power Link
Mk 3
POWER LINK socket: Use this
socket to connect the loudspeaker to one of the Power Link sockets on the Bang & Olufsen system.
Note: Do not use a Power Link cable of the older type, as this will cause noise, and therefore not give optimum sound quality! The new type has a triangular mark on the plug.
Cable clamp: For safety reasons, the mains cord from the wall outlet must be secured to the loud speaker. To do so, tug the cord behind the cable clamp.
Mains cord: The supplied mains cord and plug are specially designed for the product. If you change the plug or damage the mains cord, you must buy another from your Bang & Olufsen retailer!