Bang & Olufsen 1-Jul, 2-Jul manual with a ‘type 2 bracket’

5

Here is shown how to fasten the loudspeaker with a ‘type 1 bracket’ to a Bang & Olufsen ‘single-column’ stand (or wall bracket). Use the same procedure if you wish to fasten the loudspeaker to a Bang & Olufsen ‘double-column’ Stand

–with a ‘type 2 bracket’.

aRemove the small cover (if any) on the stand. Press the cover as

shown, and it will come loose. b Fasten the bracket to the stand or

wall bracket. Use the two longest screws (M5 × 25 mm) – four screws for a ‘type 2 bracket’.

c Fasten the loudspeaker to the

bracket. Use the two shortest

screws (M5 × 8 mm). However, do

not fully tighten the screws before

you have made the adjustments

	a
	c
b	c

mentioned below (d).

d	d
	c
	c

Adjustments: First, make sure that the television is adjusted to a level position on its stand or wall bracket! Then use the two screws (d) to adjust the loudspeaker so that it is parallel to the lower edge of the television. Align the loudspeaker front with the television and tighten the two screws (c).

NOTE! BeoVision 7 and its accessories are not available on all markets.