Bang & Olufsen 2-Jul, 1-Jul manual Set up the loudspeaker

4 Set up the loudspeaker

We recommend that you follow this procedure:

–Disconnect your Bang & Olufsen system from the mains.

–Mount the loudspeaker to the Bang & Olufsen stand or wall bracket as explained on the next page.

–Connect the loudspeaker as explained in ‘Cable connections’ (pp. 6–7).

–Set the POSITION switch to the correct setting. This is explained in ‘Adapt the loudspeaker to your room’ (pp. 8–9).

–Connect the entire system to the mains again.

In order not to dent or scratch the loudspeaker front grill, we recommend that you lift the loud- speaker by holding on to the two bass units on the bottom. Do not support the loudspeaker holding the loudspeaker front grill!

‘Type 1 bracket’

‘Type 2 bracket’

BeoLab 7 brackets: The loud- speaker must be fastened to one of the brackets shown here, and on a suitable Bang & Olufsen stand or wall bracket.

100 cm

39"

BeoLab 7-1

124 cm

49"

BeoLab 7-2

BeoLab 7-1:Always use the ‘type 1

bracket’.

BeoLab 7-2:Use the ‘type 2 bracket’ when the loudspeaker will be fastened to one of the ‘double- column’ Bang & Olufsen stands. However, use the ‘type 1 bracket’ if the loudspeaker will be fastened to a wall bracket – for example below a BeoVision 4 screen.