Data Capture
for Workforce
in Motion
3.How to connect your Baracoda scanner ?
3.1 Connection process
Here is the process to connect the scanner to the USB Plug&Scan dongle:
1.Reset the scanner (see Scanner User Guide to perform this operation).
2.Plug the dongle into the USB port of the computer.
3.Do not scan any other barcodes except the ‘connect barcode’ that is delivered with the dongle.
4.Within 5 seconds (not necessary to rescan), the connection is established.
oThe scanner beeps twice and the LED will change to a double flashing green. (*)
5.Start scanning barcodes.
(*)If the LED on the scanner is not double flashing green, this can possibly mean:
The scanner is low on power. Charge the unit up completely and try again
The scanner has not been reset. Reset it and try again
The scanner has been programmed from its default status and it is not able to decode the Code 128 symbology. Be aware that the ‘connect barcode’ is a code128 symbology and so the scanner shall stay in its default mode “Code128 on”
By default, the Plug & Scan dongle activates the “No Data Loss Mode”. (Please refer to the paragraph 3.4 for additional information)
Nota: When you will be connected with the DualRunners, you could scan barcodes and read RFID TAG ID
3.2 Embedded firmware version
Once the scanner is connected ; a capture of this barcode will forward and display the firmware version of your Plug & Scan dongle following this format “Baracoda HID vx.xx”:
Print firmware version
3.3 Disconnection process
There are 3 different ways to disconnect a scanner from the Plug&Scan dongle.
1.Reading the “disconnect” barcode with the connected barcode scanner. Use this barcode to disconnect your barcode scanner from a Plug&Scan dongle.
Disconnect barcode
2.Remove the USB dongle from the USB port (power will be OFF)
3.Connect another scanner by reading the dongle’s ‘Connect barcode’ with it (Swap process).
Baracoda USB Plug & Scan dongle – User Guide v3.33b | - 6 - |
