Barco D320PL 4.2 SDI input module, 4.3 HDSDI input module

4. Input modules

4.2 SDI input module

Technical info:

•SDIdatain.

• SDI loop through.

• 270Mbit/s transmission (SMPTE 259M-C).

• 525/625 interlaced.

•Coax(75Ohm).

• AmberLED (upper LED on the fr ont side) will be lit indicating recognition of film, either continuous or

intermittent film detection.

• Whenplaced in an in put slot the green LED (lower LED on the front side) will be lit indicating that the

system acknowledges the module.

Image 4-3 Image 4-4

Order info:

Article No. Description

R9850970 D320PL Digitizer SDI input module

4.3 HDSDI input module

Maximum two HDSDI input modules may be insertedin one D320PL Digitizer.

16 R5976470 D320PL DIGITIZER 13122002

Contents

Main Page Copyright Guarantee and Compensation Changes Trademarks Federal Communication Commission (FCC Statement) Page TABLE OF CONTENTS Page 1. SAFETY 1.1 Important Safety Instructions Instructions: 1.2 Important Warnings Important Warnings: Page Page 2. Introduction 2. INTRODUCTION 2.1 General functionality Overview 2.2 Order info D320PL Digitizer 2.3 Technical summary 2. Introduction Page Page 3. Physical Installation of the D320PL Digitize r 3. PHYSICAL INSTALLATION OF THE D320PL DIGITIZER 3.1 Installation requirements Requirements 3. Physical Installation of the D320PL Digitizer 3.2 Connections Rear panel inputs/outputs 3. Physical Installation of the D320PL Digitize r 3.3 Removing and inserting a D320PL Digitizer input module How to remove an input module from the D320PL Digitizer Page 4. INPUT MODULES Overview 4.1 DVI input module 4.2 SDI input module 4.3 HDSDI input module Page 4.4 CVBS / S-VID input module 4.5 YUV / RG(s)B input module 4.6 RGB analog input module Page 5. Cables and accessories for the D320PL Digitizer 5. CABLES AND ACCESSORIES FOR THE D320PL DIGITIZER 5.1 Cables and accessories List with available cables and accessories Page 6. CONFIGURATION SCHEMES 6.1 Stand alone configuration 6.2 Chaining configuration 6. Configuration schemes How to set up a D320PL chaining configuration 6.3 Stacking configuration Scheme 6. Config uration schemes How to set up a D320PL stacking configuration 6.4 Combined chained and stacked configuration Scheme 6. Configuration schemes How to set up a mixed configuration 7. CONTROL SOFTWARE Page 8. Maintenanc e of the D320PL Digitizer 8. MAINTENANCE OF THE D320PL DIGITIZER 8.1 Cleaning the dust filter How to clean the dust filter 8.2 Cleaning the cabinet How to clean the cabinet Page Page Page Index INDEX A C D I Page Revision Sheet