6. Configuration schemesHow to set up a mixed configuration
1. Connect the RS232 communication port of the local control PC with t he COM1 RS232input port of the
first D320PL Digitizer. This Digitizer will act as the master, all following Digit izers are slaves.
2. Connect the LOOP OUT of each previous Digitizer with the LOOP IN of the next Digitiz er.
3. Connect the LED-WALL / PROJECTOR OUTPUT of the last Digitizerof each chain with a screen. Do
thisin a lo gical order to simplify the configuration with the control sof tware. First chain driv es first screen
from the left, second chain drives second screen from the left and so on.
4. Connect each COM2 RS232 output port of the previous chained Digitizer with the COM1 RS232 input
port of the next chained Digitizer.
5. Connect each COM3 RS232 output port of the previous stacked Digitizer with the COM1 RS232 i nput
port of the next stacked Digitizer.
6. Provide the available video sources to the input modules and use the active loop through to connect
the sources withthe other stacked input modules.
Note: Thec ontrol software will recognize the chained Digitizers as one Digitizer in a sta cked configura-
tion. But instead of only 4 input slotsthe software will detect a plural of 4 input slots. Make sure
the same input source is used for the same input slot number on the different stacked Digitizers .
7. Configure the D320PL Digitizers and the Display with the cont rol software installed on the local control
PC.
26 R5976470 D320PL DIGITIZER 13122002