Barco matrix pro 8*8 DVI quick start MatrixPRO 8x8 DVI, Quick Start Guide, Quick Install

MatrixPRO 8x8 DVI	Barco, Inc.	(866) 374-7878
	Technical Support: +1
	Toll Free: +1	(888) 414-7226
	Fax: +1	(916) 859-2515

Quick Start Guide Website: www.barco.com

Visibly yours

DVI Inputs

Eight DVI inputs are provided. Use EDID

Resolution Menu to set preferred EDID resolution.

DVI Outputs

Eight DVI outputs

are provided.

Serial Port

For serial communications

and downloading code.

							SERIAL
		INPUTS				OUTPUTS	ETHERNET
5	6	7	8	5	6	7	8
1	2	3	4	1	2	3	4
							100-240V	50-60 Hz
							3.0 A

Input Valid LED
	Ethernet Port
Each input has an associated LED
that lights green to indicate the	For use with external controller
presence of a valid video signal.	and downloading code.

AC

Connect to AC power source.

Quick Install

Signal Connection and Factory Reset

1. Observe all safety precautions. Rackmount chassis, or install in “tabletop” configuration.

2. Connect outputs from DVI sources to DVI inputs 1 through 8.

3. Connect MatrixPRO outputs 1 through 8 to DVI inputs on destination devices.

4. (Optional) For Ethernet connection, use a “local” network only. Connect MatrixPRO’s Ethernet Port to hub. Connect hub to peripheral Ethernet devices.

5. (Optional) For serial connection, connect MatrixPRO’s RS-232 port to external RS-232 device (e.g., PC).

6. Turn power on.

5. (Optional) Perform a factory reset: Main Menu >

Setup > Factory Reset, SEL

This action cancels all routes, clears all presets, and resets IP address to default.

Common Setup Functions
Set EDID Resolution
1. Main Menu > EDID Setup.
2.	Scroll to “Input” line, SEL
3.	Rotate ADJUST knob to select individual or all inputs,				SEL
4.	Scroll to “Format” line,	SEL
5.	Rotate ADJUST knob to select preferred resolution,			SEL
6. Reboot external computers.
Pre-select a Test Pattern
1. Main Menu > Test Pattern.
2.	Scroll to “Output” line,	SEL
3	Rotate ADJUST knob to select individual or all outputs,				SEL
4.	Scroll to “Type” line, SEL
5.	Rotate ADJUST knob to select a test pattern,		SEL

Common Setup Functions

Enable/disable DHCP

1. Main Menu > Setup > System.
2.	Scroll to “DHCP” line,	SEL
3.	Rotate ADJUST knob to preferred setting,		SEL

Unlock Control Panel

If the panel is locked and it is required that you gain access:

1. Ensure that panel is currently (or temporarily) available for local use.

2. Press (simultaneously) SEL + ESC + TAKE

MatrixPRO 8x8 DVI Router User’s Guide

For complete details on all installation and operating procedures, please refer to the MatrixPRO 8x8 DVI Router User’s Guide.

P/N 26-0503004-00 Rev 02