7 Appliance Preparation
A.Removing
The
CAUTION
Handle with care
•
•Hold
•Remove and save two screws from upper bracket.
•Remove
•Remove and save three screws from lower bracket.
•Discard brackets.
•Replace screws in holes where brackets were attached to appliance.
CUT LINE
BEND TABS UP
Figure 7.2. Bend Tabs and Cut Insulation.
3.Discard the
B. Installing the Optional Heat-Zone® Gas
Kit
Before installing finishing materials, use these instructions to attach the
CAUTION
Sharp Edges
• Wear protective gloves and safety glasses during installation.
1.Remove the four screws that attach the Heat Zone® Cover Plate to the top of the appliance.
COVER PLATE HOLES
REMOVE SCREWS
Figure 7.1. Remove Screws.
2.Bend the four
Figure 7.3.
4.Remove the four screws securing the cover plate to the inside of the appliance and discard them along with the cover plate. See Figure 7.4.
Figure 7.4.
20 |