RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filters before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or
Always wipe dry to avoid water marks.
Cleaning Method:
■Liquid detergent soap and water, or
■Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry.
4.Bend spring clips back into place to secure the charcoal filter to the metal filter.
5.Replace metal grease filter. See “Metal Grease Filter” in this section.
Metal Grease Filter: |
| Replacing a Halogen Lamp |
1.Remove each filter by pulling the spring release handle and then pulling down the filter.
A 
A. Spring release handle
2.Wash metal filters as needed in dishwasher or hot detergent solution.
3.Reinstall the filter by making sure the spring release handles are toward the front. Insert aluminum filter into upper track.
4.Push in spring release handle.
5.Push up on metal filter and release handle to latch into place.
6.Repeat steps
Non-Vented (recirculating) Installation Filters:
The charcoal filter is not washable. It should last up to 6 months with normal use. Replace with Charcoal Filter Kit. See the “Accessories” section for information on ordering.
To replace charcoal filter:
1.Remove metal grease filter from range hood. See “Metal Grease Filter” in this section.
2.Bend spring clips away from metal grease filter.
Turn off the range hood and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new lamp, do not touch lamp with bare fingers. Replace lamp, using tissue or wearing cotton gloves to handle lamp.
If new lights do not operate, make sure the lamps are inserted correctly before calling service.
1.Disconnect power.
2.Use a
3.Remove the lamp and replace with a
4.Replace the light cover.
5.Reconnect power.
3.Place charcoal filter into top side of metal filter.
11
