Website: http://www.sharp.co.uk/support | Help Line: 08705 274277 (office hours) |
INSTALLATION
WARNING
Inspect the Oven:
•Check the oven carefully for damage before and regularly after installation.
•Make sure the door closes properly, that it is not misaligned or warped.
•Check the hinges and door safety latches are not broken or loose.
•Ensure the door seal and sealing surfaces are not damaged.
•Inspect the oven interior and door for dents.
Important:
If any damage is apparent, do not operate the oven in any way. Contact your dealer or an authorised Service Technician appointed by SHARP. (see p. 44)
1.Remove all packing materials including the feature sticker (if applicable). Do not remove the plastic film from the inside of the oven window as this protects it from dirt. The waveguide cover prevents food and grease from entering the waveguide area where it could cause damage.
DO NOT REMOVE.
2.Place oven on a secure, level surface, strong enough to take the oven weight, plus the heaviest item likely to be cooked in the oven.
3. The minimum height |
| ||
of | free | space | 21cm |
necessary above the |
| ||
top | surface | of the |
|
oven is 21cm. |
|
| |
4.The oven door may 
become hot during cooking.
5.Place or mount the oven so that the bottom of the oven is 85cm or more above the floor.
6.Do not place the oven where heat, moisture or high humidity are generated, (for example, near or above a conventional oven) or near combustible materials (for example, curtains). Do not block or obstruct air vent openings. Do not place objects on top of the oven.
7.Make sure the power supply cord is undamaged (See Installation opposite) and that it does not run under the oven or over any hot or sharp surfaces.
8.The socket must be readily accessible so that it can be easily unplugged in an emergency.
9.Do not use the oven outdoors.
This oven is not designed to be
IMPORTANT! ELECTRICAL CONNECTION.
•Do not allow water to come into contact with the power supply cord or plug.
•Insert the plug properly into the socket.
•Do not connect other appliances to the same socket using an adaptor plug.
•If the plug or socket is loose or the power supply cord is damaged, it must be replaced with a special cord. The exchange must be made by an authorised SHARP service agent.
•When removing the plug from the socket always grip the plug, never the power supply cord as this may damage the power supply cord and the connections inside the plug.
•If the fitted mains plug to your oven is a rewireable type and in the unlikely event of the socket outlet in your home not being compatible with the plug supplied, remove the plug and fit an appropriate type, observing the wiring code given in `To replace the mains plug’ on page 43.
If you wish to remove or replace the plug supplied, ensure the plug is removed properly and not cut off.
•If the plug fitted to your oven is a
Danger:
The fuse from the
Under no circumstances should the
The plug must not be used without the fuse cover fitted.
If you have any doubt about your microwave oven obtain the help of a qualified electrician.
When replacing the plug please ensure that you use a BSI or ASTA approved plug to BS1363, this should be fitted with a brown coloured 13 amp fuse approved by BSI or ASTA to BS1362. If you have any doubt about electrical connection seek the help of a qualified electrician.
WARNING: THIS APPLIANCE MUST BE EARTHED
To wire an appropriate plug, follow the wiring code given in `To replace the mains plug’ on page 43.
4
