Connect Vent System
1.Install transition on top of hood (if removed for shipping) with 2 - 3.5 x 9.5 mm sheet metal screws.
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw
For vented installations only:
1.Fit vent system over transition piece.
2.Seal connection with clamps.
3.Check that back draft dampers work properly.
For non-vented (recirculating) installations only:
1.Assemble the air deflector with the duct cover bracket with 2 assembly screws provided with the Recirculation Kit.
B 
A
2.Measure from the bottom of the air deflector to the bottom of the hood outlet.
| A |
B |
|
X | C |
D |
|
E |
|
A. Air deflector
B. Vent clamp
C. X = length to cut vent duct
D. Vent duct
E. Exhaust outlet
3.Cut the duct to the measured size (X).
4.Remove the air deflector.
5.Slide the duct onto the bottom of the air deflector.
6.Place the assembled air deflector and duct over the exhaust outlet from the hood.
7.Reassemble the air deflector to the duct cover bracket with 2 assembly screws.
8.Seal connections with vent clamps.
B
C
A. Vent cover bracket
B. 2.9 x 6.5 mm screws
C. Deflector
Make Electrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Disconnect power.
2.Remove terminal box cover.
3.Remove the knockout in the terminal box and install a UL listed or CSA approved ¹⁄₂" strain relief.
8
