F. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or scratches.
•Do NOT strike, slam or scratch glass.
•Do NOT operate appliance with glass door removed, cracked, broken or scratched.
•Replace glass door assembly as a complete appliance.
Removing Glass Assembly
Unlatch the two latches at the bottom of the glass door. Carefully pull the bottom of the door away from the unit and lower the top tabs on the door out of the top latches as tension is relieved.
Replacing Glass Assembly
Angle the top of the glass door in toward the appliance and insert the tabs on top of the glass frame into the top latches. Rotate the bottom of the glass door toward the firebox with slight upward pressure. Latch the bottom spring latches securely onto the bottom glass door tabs.
G. Burner Removal (Only for Servicing)
Loosen the shutter adjustment wing nut and move the shutter to the closed position (see Figure 12.10).
Open | Closed | Wing nut |
Figure 12.10
Remove the air baffle by removing the two screws at- taching it to the burner. Remove the two screws holding the pilot and the one screw from the front of the burner (see Figure 12.11).
Figure 12.11
Slide the burner to the right while angling the right side of the burner forward until the burner is free of the shutter sleeve, then lift out burner (see Figure 12.12).
Figure 12.12
Using a 3/8” nut driver or wrench, remove the natural gas orifice and replace it with the LP orifice provided in this kit (see Figure 12.13).
Orifice Holder | Shutter Sleeve | Burner Neck |
| ||
|
| |
|
|
|
Figure 12.13 |
|
|
41 |
