3. Kit installa tion (detailed)
3. Lift the preformatter unit a bit and unplug the following connectors:
- J100, J101, J102 on the preformatter: data from the PMP
- J11on the preformatter: powers upplyfrom the power box
- J410 on the PMP: commands from the local keypad
- J13 on the PMP:com mands from theIR receiver
4. Remove the screw fixing the three grounding wires
5. Flip over the preformatter unit
Or,
Unplug theother connectors on the preformatter unit and remove the unit
6. Remove b oth fixing screws on the front panel of the input module
Image3-2
Inputmodule: fixingfront screws
7. Remove the three screws fixing the input module to the chassis
Image3-3
Inputmodule: fixing screws chasis
8. Lift the input module a bit and unplug the connectors on the PMP:
- J15: power supply from the power box
- J19: IC2 to the desktop input
- J23; I2C from the power box
- J14: sync from the engine controller
- J22: I2C to the engine controller
- J11: ethernet wire from the front panel
- J2and J3 on the LVDS interface (which is mounted on the PMP): data from the desktop input
9. Remove the input module
3.2.2 Removing the PMPNecessary tools
Torxscrewdriv er T10
8R59770498 PMP KIT 28/02/2011