Barco GALAXY NW-12, NH-12, NW-12 How to remove the PMP?

1 35

3. Kit installation (detailed)

How to remove the PMP?

1. Remove the input module (see concerning chapter)

2. Remove both screws ﬁxing the PMP to the front plate

Image3-4

PMP:front ﬁxing screws

3. Remove the side screws ﬁxing the input boards to the PMP

Image3-5

4. Disconnect the PMP from the inputs by unplugging the board-to-board connectors

Image3-6

PMP:unplug from input boards

5. Remove the LVDS connector from the PMP (see chapter LV DS inter face )

R59770498 PMPKIT 28/02/2011 9

Contents

Main Page Changes Copyright Disposal Information Guarantee and Compensation Trademarks Page Table of contents TABLE OF CONTENTS Page 1. Safety instruct ions 1. SAFETY INSTRUCTIONS 1.1 Safety during kit installation Page 2. PMP kit 2. PMP KIT 2.1 Introduction Introduction 2.2 Kit description Scope Page 3. KIT I NSTALLATION (DETAILED) 3.1 Making a backup of the PMP to be replaced 3.2 Replacing the faulty PMP 3.2.2 Removing the PMP Necessary tools How to remove the PMP? 3.2.3 Installing the PMP How to install the PMP? Page 3.2.4 Installing the input module Necessary tools How to install the input module? 3.3 Restoring the backup Procedure 3.4 Upgrade the projector to the desired software version Introduction NW- x v03.01.0001.exe A. BACKUP AND RESTORE DATA Overview About this chapter A.1 Connectingto the projector through Projector Support How to connect to the projector? Page Special case in the Query list A.2 Making a backup of the projectors key data How to make a backup of the projectors key data? Page Page CAUTION:Itis not allowed to do any manual change to a backuple. Achanged le cannot be restored! A.3 Restoring a set of key data Different levelsof restore How to restore the key data in a used PMP? Page Page Page Page Page Page Page Page Page Index INDEX B D I K