Barco GALAXY NW-12, NH-12, NW-12

3. Kit installation (detailed)

Image3-12

PMP:ﬁxing screws of the LVDS interface

3. Connect the PMP tothe inputs by plugging in the board-to-boardconnectors

Image3-13

PMP:plug into the input board connectors

4. Fix the PMP to the input boards using the side screws

Image3-14

PMP:side screws ﬁxing the input boards

5. Fix the PMP to the front plate using two screws

R59770498 PMP KIT 28/02/2011 11

Contents

Main Page Changes Copyright Disposal Information Guarantee and Compensation Trademarks Page Table of contents TABLE OF CONTENTS Page 1. Safety instruct ions 1. SAFETY INSTRUCTIONS 1.1 Safety during kit installation Page 2. PMP kit 2. PMP KIT 2.1 Introduction Introduction 2.2 Kit description Scope Page 3. KIT I NSTALLATION (DETAILED) 3.1 Making a backup of the PMP to be replaced 3.2 Replacing the faulty PMP 3.2.2 Removing the PMP Necessary tools How to remove the PMP? 3.2.3 Installing the PMP How to install the PMP? Page 3.2.4 Installing the input module Necessary tools How to install the input module? 3.3 Restoring the backup Procedure 3.4 Upgrade the projector to the desired software version Introduction NW- x v03.01.0001.exe A. BACKUP AND RESTORE DATA Overview About this chapter A.1 Connectingto the projector through Projector Support How to connect to the projector? Page Special case in the Query list A.2 Making a backup of the projectors key data How to make a backup of the projectors key data? Page Page CAUTION:Itis not allowed to do any manual change to a backuple. Achanged le cannot be restored! A.3 Restoring a set of key data Different levelsof restore How to restore the key data in a used PMP? Page Page Page Page Page Page Page Page Page Index INDEX B D I K