3. Physical i nstallation
When this is achieved, thep rojectoris set horizontal and vertical at right angles to the screen.
SCREEN
SCREEN
Image3-11
3.4 Suspension of the CLM projector with rigging clamps
Beforethe projector can be suspended,the optional carry handle must be mounted on the projector. For more
informationabout the optional carry handle, see "Mountingoptional Carry handle", page 211.

CAUTION:Consult a professional structural engineer to ensure thatt hesusp ension system is suitablefor

this task.

Rigging points and rigging clamps

Thecarry handle is provided with six slots. Fourslots are longitudinally oriented (A) and two slots are transversely oriented (B). In
eachslot, a rigging point can be inserted (this rigging point is mounted on the clamps) and the position in the slot can be adjusted
dependingof the size of the truss installation. Therigging clamps turn in these rigging points and these clamps allow an easy and
fastphysical setup of the projector in a hanging configuration.
A
A
B
C
Image3-12
Riggingslotsandclamps
Necessary tools
Open end spanner 17 mm
Necessary parts
• Four rigging clamps (R855943)
• Safety cable (B361213)
• Two snap hook locks (B361212)

Mounting the rigging points into the handle

1. Push the cup square neck bolt through the slot input and slide the bolt into the slot.
Note: Takethe bolt by its thread so that it does not fall inside the carry handle.
R59770057 CLM HD8 15/03/2010 25