3. Setup of the B-10 Mobile LED
How to move down?
1. Lift down the display till it’s on the bottom.
Note: Do not forget to take away the safety pieces from the mast.
Caution: Watch out that cables are not under the display.
2. Open the pump system and lift up the display a little.
3. Close the pump.
4. De-fasten the 2 half display and unplug the power and data cables.
5. Push back the bottom half display and fasten it with the 4 fasteners.
6. Lift down the top half display till it is on the bottom.
3.6 Preparing for departure
Steps to be taken
1. Retract the rear stabilizers.
2. Retract the front stabilizers.
3. Turn the jockey wheel downwards till the wheel touches the ground.
Note: Do not lift the trailer at the front side.
4. Bring the tong of the trailer to the height of the ball hitch so that the trailer has exactly the same height at the front and at the rear.
5. Release the brake system of the B-10 Mobile LED trailer.
6. Lift up the tong of the trailer a little with the jockey wheel and hitch it to the ball hitch.
7. Place the wooden plate in the B-10 Mobile LED trailer.
8. Retract the jockey wheel completely.
Caution: Only use the jockey wheel to hitch and unhitch the trailer on & from the ball hitch. After usage, always wind the jockey
wheel fully up to avoid damages on the jockey wheel.
R5976956 B-10 MOBILE LED 19/06/2007 25