Barco R9855510 3. SETUP OF THE B-10 MOBILE LED

3. Setup of the B-10 Mobile LED

3. SETUP OF THE B-10 MOBILE LED

Overview

• Installation of the B-10 Mobile LED

• Powering the B-10 Mobile LED

• Extending the LED display

• Rotating the LED display

• Move down the LED Display

• Preparing for departure

In order to set up the B-10 Mobile LED more easily the following tools may be useful to purchase:

• A level to verify the flat position of the trailer

• A drill to position the 4 outriggers and fasten the 2 halves LED display parts together (4 bolts)

1. Place the trailer on a flat and hard ground.

2. Unhitch the trailer from the ball hitch. For this purpose, you may need to use the jockey wheel. After using the jockey wheel wind

it fully up to its initial (up) position.

Note: After using the jockey wheel wind it fully up to its initial (up) position.

Caution: Only use the jockey wheel to engage and disengage the trailer on & from the towing hook. After usage, always wind

the jockey wheel fully up to avoid damages on the jockey wheel.

Image 3-1

3. Trigger the brake system of the B-10 Mobile LED (back position)

4. Take the wooden plate (in the B-10 Mobile LED left at door entrance) and position them below the outriggers.

5. Start by extending the front stabilizer.

Tip: If the stabilizers cannot reach the wooden plates, put additional wooden plates under the outriggers.

6. Retract the jockey wheel completely.

Caution: After using the jockey wheel wind it fully up to its initial (up) position. Only use the jockey wheel to engage and

disengage the trailer on or from the towing hook.

Caution: A jockey wheel may have a maximum allowed load of 250 kg. Do not use the jockey wheel faulty as it can damage

the wheel and the folding system.

7. Extend the rear stabilizers.

8. Level the B-10 Mobile LED vehicle and try to position it as “flat” as possible in the length and the width. Use therefore a level

and adjust the stabilizers accordingly.

1. Put the contact in the warm up position. After several seconds turn-on the generator with the contact key.

R5976956 B-10 MOBILE LED 19/06/2007 21