Bard W17A, W60A manual Minimum Clearances Required to Combustible Materials, Form No S3397 November

Clearances Required for Service Access and Adequate Condenser Inlet Airflow

MODELS	LEFT SIDE	RIGHT SIDE
W17A, W18A, W24A, W30A, W36A	15"	20"
W42A, W48A, W60A	20"	20"

NOTE: For side by side installation of two (2) WA models there must be 20" between units. This can be reduced to 15" by using a WL model (left side compressor and controls) for the left unit and WA (right side compressor and controls) for right unit.

See WL Specifications S3400.

Minimum Clearances Required to Combustible Materials

MODELS 1	SUPPLY AIR DUCT	CABINET
	FIRST THREE FEET
W17A, W18A, W24A	0"	0"
W30A, W36A	1/4"	0"
W42A, W48A, W60A	1/4"	0"

1Refer to the Installation Manual for more detailed information.

Dimensions of Basic Unit for Architectural and Installation Requirements (Nominal)

MODEL	WIDTH	DEPTH	HEIGHT	SUPPLY		RETURN
	(W)	(D)	(H)	A	B	C	B	E	F	G	I	J	K	L	M	N	O	P	Q	R	S1	S2	T
W17A
W18A	33.300	17.125	70.563	7.88	19.88	11.88	19.88	35.00	10.88	25.75	20.56	26.75	28.06	29.25	27.00	2.63	34.13	22.06	10.55	4.19	12.00	12.00	5.00
W24A
W30A	38.200	17.125	70.563	7.88	27.88	13.88	27.88	40.00	10.88	25.75	17.93	26.75	28.75	29.25	27.00	2.75	39.13	22.75	9.14	4.19	12.00	12.00	5.00
W36A
W42A
W48A	42.075	22.432	84.875	9.88	29.88	15.88	29.88	43.88	13.56	31.66	30.00	32.68	26.94	34.69	32.43	3.37	43.00	23.88	10.00	1.44	16.00	16.00	1.88
W60A

All dimensions are in inches. Dimensional drawings are not to scale.

								E
		Built In		D				O
		Rain Hood		1	1			31.88	1
		4° Pitch		7.88
	W	Heater			1.00					.44
		Access			2.13
		Panel									R
		Electric					Side Wall	Supply Air Opening
					A
		Heat					Mounting
							Brackets
		C. Breaker/
							(Built In)				S1
		Disconnect						B
		Access Panel			I
		(Lockable)					Top Rain
		ERV and ECONWMS					Flashing				S1
							Shipping
		only hood
							Location
5.88	Filter Access Panel	Standard flush	3"
		vent door for					Optional
		non-ERV/Econ.			C	H	Electrical	Return Air Opening			S1
		models					Entrances
F	Ventilation Air
											S2
G		Low Voltage			K
	Condenser			Cond.			L
		Electrical			J
	Air Outlet	Entrance		Air			M				S2
		High Voltage		Inlet			P
		Electrical
		Entrance									T
					Drain		N			Bottom Installation
		Equipment Building Hood
	Front View			Side View			Q	Back View		Bracket
		ECONWMT-E2, -T2, -E3, -T3 is 16"
											MIS-3122
		ECONWMT-E5, -T5 is 18"

1Optional top outlet (factory installed only) for W30A and W36A models only.

Bard Manufacturing Company, Inc.

Bryan, Ohio 43506

www.bardhvac.com

Since 1914 . . . Moving ahead, just as planned.

Form No.	S3397-1112
Supersedes	S3397-712
Page	12 of 12

Due to our continuous product improvement policy, all specifications subject to change without notice.

Before purchasing this appliance, read important energy cost and efficiency information available from your retailer.

Form No.

S3397

November, 2012

Supersedes: S3397-712