Bard WG4S1, WG5S1, WG3S1 warranty WG 3 S, B X, Optional Field Installed Accessories

Air Conditioning Wall-Mount Model Nomenclature

WG 3 S 1	A	X	B
MODEL

B X X X X X

NUMBER	REVISION
		EMISSIONS
COOLING	CODE
		X - Standard
CAPACITY
		N - NOx Certified*
3 - 3 Ton
4 - 4 Ton
5 - 5 Ton
STEP CAPACITY	VOLTS & PHASE
	A - 230/208-60-1
SPECIALTY	B - 230/208-60-3	HEATING INPUT

FILTER OPTIONS

X- 2-inch Pleated W - 1-inch Washable

VENT OPTIONS

(See Table)

CONTROL MODULES (See Table)

COIL OPTIONS

X - Standard

1 - Phenolic Coated Evap.

2 - Phenolic Coated Cond.

3 - Phenolic Coating on both coils

PRODUCTS C - 460-60-3 A = 50,000

(Non-Standard)	B = 75,000
	C = 100,000
C= Canadian Approval
	D = 125,000*

*125,000 BTU input model is not NOx certified.

COLOR OPTIONS
X - Beige (Standard)
		OUTLET OPTIONS
4	- Buckeye Gray
		X - Front (Standard)
8	- Dark Bronze

T - Top

Ventilation Options

Models		WG3S, WG4S, WG5S
Description		Factory Installed	Field Installed
		Code No.	Part No.
Blank-Off Plate (Standard)		B	WGSBOP-5
Commercial Ventilator - Modulating Spring Return w/Exhaust		V	WGSCRVMP-5
Economizer (Internal) Fully Modulating w/Exhaust	1	E	WGSEIFM-5
Energy Recovery Ventilator - 230 Volt w/Exhaust	2	R	WGSERV-A5A-
Energy Recovery Ventilator - 460 Volt w/Exhaust	2	R	WGSERV-C5A-

1 Low ambient control is required with economizer for low temperature compressor operation. 2 Independent selection of intake and exhaust speeds (rate) with terminal block selection.

Color option must be specified to match unit ("X" = Beige; "4" = Buckeye Gray; "8" = Dark Bronze)

Top Supply Outlet Conversion Kits - Field Installed

USED WITH MODELS	UNIT COLOR X - BEIGE	UNIT COLOR 4 - BUCKEYE GRAY	UNIT COLOR 8 - DARK BRONZE
WG3S, WG4S, WG5S	TSO-WG5-X	TSO-WG5-4	TSO-WG5-8

Air Conditioning Control Modules (All Models Except as Noted)

HPC 1	LPC 2	CCM 3	LAC 4	SK 5	Factory Installed Code	Field Installed Part
STD	STD	STD			X	N/A
STD	STD	STD			H	CMA-28
STD	STD	STD			Field Installed Only	SK114 for WG3S1-A
STD	STD	STD			Field Installed Only	SK111 for WG4S1-A
STD	STD	STD			Field Installed Only	SK115 for WG5S1-A

STD = Standard equipment for these specified models.

1 HPC. High pressure control is auto reset. Always used with compressor control module (CCM) which is included. See note 3. 2 LPC. Low pressure control is auto reset. Always used with compressor control module (CCM) which is included. See note 3.

3CCM. Compressor control module has adjustable 30-second to 5-minute delay-on-break timer. On initial power-up, or any time the power is interrupted, the delay-on-make will be 2-minutes plus 10% of the delay-on-break setting. There is no delay-on-make during routine operation of the unit. The module also provides the lockout feature (with 1 retry) for high and/or low-pressure controls, and a 2-minute timed bypass for low-pressure control.

4 LAC. Low ambient control permits cooling operation down to 0°F.

5 SK. Start capacitor and potential relay start kit can be used with all -A single phase models. Increases starting torque 9x. Not used for -B or -C three phase models.

Optional Field Installed Accessories

DESCRIPTION	PART NUMBER
Natural Gas High Altitude Pressure Switch Kit (6000 - 10,000 Feet)	8620-189
Note: Natural Gas Orifice Change May Be Required Depending Upon Altitude and Gas BTU content. See Orifice and Altitude Tables.
Propane Gas Conversion Kit (0 - 6000 Feet Altitude)	WGCK-1
Propane Gas Conversion Kit (6000 - 10,000 Feet Altitude)	WGCK-2
Vertical Vent Kit (Includes all parts for 5 foot vertical vent)	VVK-5A
Additional 1 foot vertical vent pipe section for VVK-5A	8620-201
Additional 2 foot vertical vent pipe section for VVK-5A	8620-170
Additional 3 foot vertical vent pipe section for VVK-5A	8620-200
Additional 5 foot vertical vent pipe section for VVK-5A	8620-171

Bard Manufacturing Company, Inc.

Bryan, Ohio 43506

www.bardhvac.com

Form No.	S3396-1112
Supersedes	S3396-212
Page	12 of 12

Due to our continuous product improvement policy, all specifications subject to change without notice.

Before purchasing this appliance, read important energy cost and efficiency information available from your retailer.

Form No.

S3396

November, 2012

Supersedes S3396-212