Door gasket
9You should regularly check to see if any deposits have formed, or there are any foreign bodies in the rubber door gasket. This sits inside the opening of the porthole door.
Error code failure system
If your appliance senses that it is not operating correctly, then an error code may appear in the LCD display.
The following error codes can possibly be remedied by the customer and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTENANCE ON THE APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS POWER SUPPLY.
No display
oPower failure.
oCheck that the power plug is in the mains socket correctly. o Check the mains fuse.
F01- No water coming into the machine
oCheck the water pressure of your mains water supply. o Clean the mesh filter that sits in the inlet hose.
o Make sure the water tap that the machine is connected to is turned on fully.
F02- The machine will not drain or spin
oClean the drain pump filter.
oCheck the drain hose is not blocked or kinked.
F04- The machine does not start
oCheck that the door has been shut properly before commencing a wash cycle.
C03- The machine has sensed an out of balance load
oThis may be due to uneven distribution of clothes in the drum, which may cause an excessive level of vibration.
oSee the “General troubleshooting” section.
F05 – F10- Contact Baumatic Service Department
Once the machine has been plugged back into your mains power supply, to clear the fault code from the LCD display, you should turn on the machine and hold down the Start/Stop button for approximately 5 seconds.
26
