OPENING AND
CLOSING THE
SENSOR
•Loosen the retaining nut until the cable slides easily into • Connect the quick disconnect terminal block to the main electronic
the grommet ; | circuit ; |
• Partially unscrew the 2 front cover screws ; | • Slide the main electronic circuit into the 2 housing slot guides and |
• Pull out the front cover with the 2 front cover screws. | pull the main cable gently at the same time ; |
| • Gently push the front cover and make sure that the external |
| housing is properly seated (front cover must be flush with housing). |
| • Screw the 2 front cover screws and tighten the retaining nut. |
BRACKET
MOUNTING
WIRING
YELLOW | COM 1 |
WHITE | NC 1 |
PINK | NO 1 |
BLACK | COM 2 |
RED | NC 2 |
BLUE | NO 2 |
•Check that both locking collars are at the same position
•Align the bracket slot to the locking collar guide as shown
To insert or to remove the cable:
•Unscrew the retaining nut
•Pass the cable through the retaining nut and the grommet
•Screw the retaining nut
SENSOR
Ceiling mounting
Wall mounting
DIMENSIONS2.5 in
AND MOUNTING
6.5 in 6 in
5 in
6.25 in
|
| 3 in | |||
6 in |
| 5.5 in |
| ||
| |||||
|
|
|
|
| |
5 in
6.25 in
Bracket dimensions
Note: The
75.5268.01 20070111 | Page 2 of 7 |
