10Operating Instructions Beefeater Barbecues
Before Lighting
1. | Check that all gas hose fittings and connections are |
| spanner tight. Gas regulators that are fitted with a hand |
| tightening wheel should be checked to ensure that the |
| connection is secure. |
2. | Check that control knobs are in the Off position. Note |
| that when in the Off position the knob is locked for |
| safety and can only be operated by pressing before |
| turning. |
3. | Open the roasting hood fully or remove the weather |
| cover/lid from the cooking surface before operating the |
After Use
1.Be sure to turn off all control knobs and cylinder valve (for Propane - LPG) or
2.Clean drip tray, griddle plates. and grills if necessary
Allow barbecue to cool before replacing the weather cover/ lid or any polyester barbecue cover.
Push in
High
Low
Lighting Instructions
Off
Press and turn knob slowly to HIGH If ignition does not occur return
to OFF and repeat after 5 minutes
Hold
High
Low
Lighting Instructions
Off
Press and turn knob slowly to HIGH If ignition does not occur return
to OFF and repeat after 5 minutes
Release
High
Low
Lighting Instructions
Off
Press and turn knob slowly to HIGH
If ignition does not occur return to OFF and repeat after 5 minutes
High | Adjust |
| High - Low |
Low | Setting |
Lighting Instructions
Off
barbecue. |
4. Clean cooking surfaces thoroughly before use. |
. Turn5.Checkon gasgassupplysupplyat either the
cylinder (for Propane / LPG) or
‘Quartz Start’ Ignition
1.Push in and hold the control knob down while turning slowly in a
Note: There is a safety lock that prevents the knob from being.turnedYoumuston pushaccidentallythe knob in
completely to disengage the lock.
2.Hold the control knob in while continuing to turn the knob to the High or twelve o’clock position.
3.The starter mechanism will click and the main burner will now light. Continue turning the knob slowly until it is in the twelve o’clock position.
4.If the burner is alight, release the knob.
Note: If the burner does not light, keep the control knob pushed in and turn the control knob in a clockwise direction to return to the Off position. Wait 5 minutes for the gas to disperse and then repeat steps
5.The control knob can now be turned to the desired heat setting - Low, Medium or High.
The control knob does not need to be pushed in while selecting the heat setting.
To Turn Off The Burner
Push in and hold the control knob while turning in a clockwise direction until the Off position is reached.
Press and turn knob slowly to HIGH If ignition does not occur return
to OFF and repeat after 5 minutes
