8EURORACK UB1202/UB1002/UB802/UB502 User Manual
2.3.2Monitor and main mix
Fig. 2.9: Monitor/main mix connectors
Fig. 2.10: Monitor control and main mix fader
PHONES/CONTROL ROOM
The stereo PHONES jack (at the top of the connector panel) is where you connect headphones. The unbalanced CONTROL ROOM OUT jacks carry the summed effects and main mix signals, as well as soloed channel signals.
The PHONES/CONTROL ROOM control adjusts the level of both headphones and main monitor outputs. The UB502 is not equipped with control room outputs.
MAIN MIX
The MAIN OUT connectors are unbalanced mono jacks. The main mix signal appears here at a level of 0 dBu. The MAIN MIX fader adjusts the volume of these outputs. The EURORACK UB802 and UB502 mixing consoles feature a rotary control for this purpose.
2.3.3 Tape connectors
TAPE INPUT
The TAPE INPUTs are used to bring an external signal source (e.g. CD player, tape deck, etc.) into the console. They can also be used as a standard stereo line input, so the output of a second EURORACK or BEHRINGER ULTRALINK PRO MX882 can be connected.
Fig. 2.11: Tape input/output
Alternatively the line or tape output of a
TAPE OUTPUT
These connectors are wired in parallel with the MAIN OUT and carry the main mix signal (unbalanced). Connect the TAPE OUTPUT to the inputs of your recording device. The output level is adjusted via the
2.3.4 Signal assignment
Fig. 2.12: Assignment switches of the main section
TAPE TO MIX
When the TAPE TO MIX switch is depressed, the
TAPE TO CTRL ROOM (502: TAPE TO PHONES)
Press the TAPE TO CTRL ROOM/PHONES switch if you want to monitor the
◊If you are recording a signal via the TAPE OUTPUT and wish to listen to this simultaneously via the TAPE INPUT, do not use the TAPE TO MIX switch. Doing this would create a feedback loop, since the signal would be routed, via the main mix, back to tape via the TAPE OUTPUT. To monitor the TAPE INPUT, use the TAPE TO CTRL ROOM switch to assign the tape signal to the monitor(s) or headphones. This will avoid the tape signal being routed to the TAPE OUTPUT.
FX TO CTRL ROOM
If you want to monitor only the FX send signal in your headphones or monitor speaker(s), press the FX TO CTRL R switch. This mutes the main mix signal while routing the FX SEND output to the monitor(s). The EURORACK UB802 and UB502 do not feature this switch.
2.3.5 Phantom power and LED displays
Fig. 2.13: Phantom power and control LEDs