Beko CCB 5140 XA user manual 3Installation, Electrical connection, Preparation

Models: CCB 5140 XA

1 16
Download 16 pages 21.19 Kb
Page 7
Image 7
3Installation

3Installation

Caution:

A Preparation of the installation place and electric wiring is the responsibi- lity of the customer.

Note:

The height between the lower surfa- ce of the hood and upper surface of the oven/hob should not be less than

C 65 cm.

Assembly and electrical connections must be carried out by specialized personnel.

Remove the protective film (if any) on the hood and flue surface after the installation.

3.1.Electrical connection

The hood shall be connected to an ungrounded mains outlet that is protected by a fuse with pro- per capacity.

Your appliance is manufactured with a supply cord with 2 threads, and it should be connected to the mains supply with an electric switch that has a minimum clearance of 3 mm between the 2-pole terminals.

A Caution:

Have a qualified electrician perform the electric connection.

Note:

Connection shall comply with natio- nal regulations.

The power outlet shall be reached easily after installation.

C Voltage and fuse protection al- lowed is specified in “Technical Specifications.”

Specified voltage shall be equivalent with your mains voltage.

Do not connect the appliance with extension cords or multiple outlets.

Note:

An omnipolar switch with a minimum opening of 3mm between contacts, in line with the electrical load and local standards, must be placed

C between the appliance and the mains network in the case of direct connec- tion to the mains network.

Once the electrical connection has been completed, check that the top illumination, motor and speeds work properly.

Caution:

A Any damaged power cord must be replaced by a qualified electrician. Do not operate the appliance before it is repaired! Risk of electric shock!

3.2 Preparation

Make a rectangular opening in the base of the overhead cupboard or hood, leaving a minimum of 13 mm from the outer edges according to the dimensions indicated in the table.

Drill a hole into the upper side of the cupboard in accordance with the dimensions of the duct used for both the extraction and recirculation.

Dismantle the ducting support by pulling the two knobs (A) (fig. 1) simultaneously:

Figure 1

Hood / User Manual

7 / 11 EN

 

 

Page 7
Image 7
Beko CCB 5140 XA user manual 3Installation, Electrical connection, Preparation