INSTALLATION INSTRUCTIONS

1.If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:

From Cookers

4" (100 mm)

From Radiators

12"

(300 mm)

From Fridges

4"

(100 mm)

2.Make sure that sufficient room is provided around the appliance to ensure free air circulation. Ideally, ensure you allow gaps as shown in the below diagram.

3.The appliance should be located on a smooth surface.

4.Refer to "Cleaning and Care" section to prepare your appliance for use.

5.Fit the two plastic wall spacer supplied with the appliance rotating 1/4 turn to the condenser at the back of the freezer (see diagram).

6.If the freezer is installed in unheated areas, garages etc., in cold weather condensation may form on the outer surfaces.

This is quite normal and is not a fault. Remove the condensation by wiping with a dry cloth.

4

Page 5
Image 5
Beko CF1300APW manual Installation Instructions