TR
26
• Ifthefiltersareverydirty,youcan
pull them out by means of pliers and
clean them.
• Takeoutthefiltersontheflat
ends of the water intake hoses
together with the gaskets and clean
thoroughly under streaming water.
• Replacethegasketsandfilters
carefully and tighten the hose nuts
by hand.
Draining any remaining water and cleaning the pump filter
Filter system in your machine prevents
solid items such as buttons, coins and
fabric fibers clogging the pump propeller
during discharging of the washing
water. Thus, a good water discharger is
achieved and the pump life is extended.
• Ifyourmachinefailstodrainthe
water, the pump filter may be
clogged.Youmayhavetoclean
it every 2 years or whenever it is
blocked plugged. Water must be
drained off to clean the pump filter.
In addition, water may have to be
drained off completely in the following
cases:
• beforetransportingthemachine
(e.g.whenmovinghouse)
• whenthereisthedangeroffrost
In order to clean the dirty filter and
dischargethewater;
1- Disconnect or unplug the machine
from the power supply.
A There may be water at 90°C in the
machine. Therefore, the filter must
be cleaned only after the inside
water is cooled down to avoid
hazard of scalding.
2-Openthefiltercap.Thefiltercap
may be composed of one or two pieces
according to the model of your machine.
If it is composed of two pieces, press
the tab on the filter cap downwards and
pull the piece out towards yourself.
If it is composed of one piece, hold it
from both sides and open it by pulling
out.
3- An emergency drain hose is supplied
withsomeofourmodels.Othersarenot
supplied with this item.
If your product is supplied with an
emergency drain hose, do the following
asshowninthefigurebelow:
• Pulloutthepumpoutlethosefrom
its housing.
• Placealargecontainerattheendof
the hose. Drain the water off into the
container by pulling out the plug at
the end of the hose. If the amount
of water to be drained off is greater
than the volume of the container,
replace the plug, pour the water out,
then resume the draining process.
• Afterdrainingprocessiscompleted,
replace the plug into the end of the
hose and fit the hose back into its
place.
If your product is not supplied with an
emergency drain hose, do the following
asshowninthefigurebelow:
• Placealargecontainerinfrontof
the filter to receive water flowing