EDGE CLEANER
Active brush edge cleaners are on both sides of the
OVERLOAD PROTECTOR
The
canister motor will continue to run.
To correct problem: See
TROUBLESHOOTING.
To reset: Push in the overload protector button.
SUCTION CONTROL
The suction control allows
you to change the vacuum
SuctionSuction suction for different fabric
and carpet weights. Opening the control
decreases suction for draperies and
lightweight rugs,'=whileclosing the control
increases suction for upholsteries and
carpets.
Personal InjuryHazard
Always unplugthe vacuum cleaner before cleaning the brush area as brush may suddenly restart. Failure to do so can result in personal Injury.
AUTO-CLEANINGSYSTEM
This vacuum is equipped with an
POWER-MATE ® STORAGE
m
The lower wand has !! a "U" shaped flange
in the area where
the power cord attaches. The canis- ter has a "U"
shaped slot near
the rear of the canis- ter.
The slot allows the wands and
The wand will slip out of the slot as it is lift- ed up for use and will slide into the slot as it is lowered for storage.
THERMAL PROTECTOR
This vacuum has a thermal protector which automatically trips to protect the vacuum from overheating. The thermal protector turns the motor off automatically to allow the motor to cool in order to prevent possible damage to the vacuum.
To reset: Turn off and unplug the vacuum from the outlet to allow the vacuum to cool. Check for and remove any clogs. Also check and replace any clogged filters.Walt
approximately 30 minutes and plugthe vacuum in and turn back on to see if the
thermal protector has reset. In some cases, the unit may suddenly restart. DO NOT leave unattendedwhile plugged in.
11