Kenmore 116.23637C owner manual Secondary Filter, Exhaust Filter, To Replace Filter

SECONDARY FILTER

FOAM

Electrical Shock Hazard

Do not operate the cleaner without the motor safety filter. Be sure the tilter is properlyInstalled to prevent motor fail- ura and/or electrical shock.

Always unplug power cord from electri-

cal outlet before performing any ser- vice on vacuum,

Check secondary filter frequently and clean when dirty,

Remove the dust bin as outlined in the DUST BIN CLEANING section.

Remove secondary filter from vacuum cleaner.

EXHAUST FILTER

HEPA

The exhaust filter must be replaced when dirty. It should be replaced regularly

depending on use conditions.

The filter CANNOT be washed as it will lose its dust trapping ability.

NOTE: See PARTS AND FEATURES for the exhaust filter number.

Press release tab

on filter cartridge and pull out of canister. (Cover not shown for

clarity).

Remove filter

from cartridge by pushing out through the slot in the cartidge.

Filter

Wash the secondary filter in warm soapy water, rinse anddry thoroughly by squeez- ing the filter in your hand and letting it air dry.

DO NOT wash in the dishwasher.

DO NOT install damp.

Replace dry secondary filter. Ensure filter is properly installed over filter opening.

Replace the dust bin as outlined in the DUST BIN CLEANING section.

TO REPLACE FILTER

Slide new filter into

cartridge so that the foam side will face towards the canister, as shown.

The filter

should be

placed into the cartridge so that the ,,A.

symbols align.

Replace the exhaust filter catridge by plac- ing tabs in slots and pushing down until cartridge

J snaps into place.

15