2Installation
Refer to the nearest Authorized Service Agent for installation of the product. To make the product ready for use, make sure that the electricity and water drainage system are appropriate before calling the Authorized Service Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out.
C Preparation of the product's location as well as the electrical and waste water installations is under customer's responsibility.
BInstallation and electrical connections of the product must be carried out by the Authorized Service Agent. Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorized persons.
APrior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety.
ALet your dryer wait for 12 hours before starting to use it.
Appropriate installation location
•Install the product on a stable and level surface.
•Dryer is heavy. Do not move it by yourself.
•Operate your product in a well ventilated,
•Do not block the air ducts in front of and under the product with materials such as long pile rugs, wooden blocks and bands.
•Do not install the product behind a door with a lock, sliding door or a hinged door which can strike the product.
•Once the product is installed, it
should stay at the same place where its connections have been made. When installing the product, make sure that the rear wall of it does not touch anywhere (tap, socket, etc.). Also pay attention to select an installation location which you will not be required to change afterwards.
• Place the product at least 1.5 cm away from the edges of other furniture.
BDo not place the product on the power cable.
Removing the transportation safety assembly
ARemove the transportation safety assembly before using the product for the first time.
1.Open the loading door.
2.There is a nylon bag inside the drum that contains a piece of styrofoam. Hold it from its section marked with XX XX.
3.Pull the nylon towards yourself and remove the transportation safety assembly.
AMake sure that no part of the transportation safety assembly remains inside the drum.
Under counter installation
•This product can be installed under a counter if the height of the counter is sufficient.
6 EN
