1.Separate the union from the tap adaptor. (Figure A)
2.Install the tap adaptor to 1/2” valve fitting as shown in the figure. (Figure B)
3.After inserting the water pipe to the union, install it to the tap adaptor and insert to the tap as shown in the figure. (Figure C)
4.Tighten the union manually. In case of a leak use a spanner or a pair of pliers to tighten the union.
A Warning: Secure the water pipe to suitable points by means of the pipe clips supplied to avoid any damage or displacement or accidental disconnection.
A Warning: After turning on the water valve, make sure that there is no leakage at both connection points of the water pipe. In case of a leak, turn off the valve immediately and tighten all joints again using a spanner or a pair of pliers.
A Warning: Make sure that standard 1/2" valve fitting fed by cold mains water supply is available and is turned off fully.
Note
Note -2: Pump must be used when jug will be used.
16
EN