Operating Instructions
Remote
Control
Operations
The controls will look like the following.
Controls
Signal transmitter
5 |
|
| 1 |
6 |
|
|
|
|
|
| 3 |
4 |
|
|
|
2 |
| CANCEL | 10 |
|
| ||
|
| 9 | |
7 | OFF | SET | |
ON | 12 | ||
11 |
| AUTO CLEAN | |
|
|
| |
8 |
|
| 17 |
13 |
|
| 14 |
|
|
| |
15 |
|
| 16 |
Operation starts when this button is pressed and stops when the button is pressed again.
2.OPERATION MODE SELECTION BUTTONUsed to select the operation mode.
3. ROOM TEMPERATURE SETTING BUTTONSUsed to select the room temperature.
4. INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS.
5. JET COOLUsed to start or stop the speed cooling.(speed cooling operates super high fan speed in cooling mode.)
6. CHAOS SWING BUTTONUsed to stop or start louver movement and set the desired up/down airflow direction.
7.ON/OFF TIMER BUTTONSUsed to set the time of starting and stopping operation. (See page 22)
8.TIME SETTING BUTTONSUsed to adjust the time. (See page 22)
9.TIMER SET/CANCEL BUTTONUsed to set the timer when the desired time is obtained and to cancel the Timer operation. (See page 22)
10.SLEEP MODE AUTO BUTTONUsed to set Sleep Mode Auto operation. (See page 22)
11.AIR CIRCULATION BUTTONUsed to circulate the room air without cooling or heating. (See page 23)
12.ROOM TEMPERATURE CHECKING BUTTONUsed to check the room temperature.
ENGLISH
Operation Mode 
Cooling Operation
Auto Operation or Auto Changeover 
Healthy Dehumidification Operation
Heating Operation
13.NEO PLASMA(OPTIONAL) Used to start or stop the
14.HORIZONTAL AIRFLOW DIRECTION CONTROL BUTTON (OPTIONAL) Used to set the desired horizontal airflow direction.
15.RESET BUTTONUsed prior to resetting time.
16.2nd F ButtonUsed prior to using modes printed in blue at the bottom of buttons. (See page 21)
| • Cooling Model( ), Heat Pump Model( ) | 17. AUTO CLEAN (OPTIONAL) |
| Used to set Auto Clean mode. |
Owner's Manual 13
