Beko TLDA 662 manual Front plastic trim 2. Interior light 3. Thermostat knob

Models: TLDA 662

1 10
Download 10 pages 56.34 Kb
Page 4
Image 4
1.Front plastic trim

IMPORTANT

INSTALLATION INSTRUCTIONS

1.The space in the room where the appliance is installed must not be smaller than 10 cubic metres.

2.If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:

From Cookers

2"

(50 mm)

From Radiators

12" (300 mm)

From Refrigerators or Freezers

1"

(25 mm)

Allow a minimum of 60 mm (2.4 inches) between the top of the fridge and the ceiling or the underside of a wall cupboard.

3.Make sure that sufficient room is provided around the appliance to ensure free air circulation.

4. Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn to

the condenser at the back of the refrigerator (see diagram).

5. The appliance should be located on a

smooth surface. The two front feet can be adjusted as required. To ensure that

your appliance is standing upright adjust

the two front feet by turning clockwise or anti-clockwise, until the product is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise.

6.Refer to "Cleaning and Care" section to prepare your appliance for use.

7.This appliance has been designed to operate in ambient temperatures beetween +10 and +32 degrees C (50 and 90 degrees F).Therefore if the appliance is installed in an unheated / cold room (E.g.: Conservatory / annex / shed / garage etc.) then the food in the larder fridge [In particular salad, fruit, water and fruit juices] will start freezing because of the cold ambient temperature when the temperature drops below 0 C [Zero degrees Centigrade]. The appliance will resume normal operation when the ambient temperature rises back above +5 C. Please note, between 0 C and +5 C, the compressor will not run but the temperature in the larder fridge will be safe to store your food anyway. So don't worry when the compressor does not operate between 0 C and +5 C.

8.A special receptacle is supplied to store the mains plug during transit.

The receptacle is fixed at the back of the cabinet, on the right hand side of the compressor. (See diagram) Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the appliance. In the case of transportation, ensure you locate the plug in the receptacle

provided to avoid transit damage.

5

 

GETTING TO KNOW YOUR LARDER FRIDGE

1

12

11

 

2

 

3

13

4

11

 

5

 

4

11

 

4

11

 

4

 

6

14

 

7

 

8

 

9

 

10

 

Arrangement Examples (See diagram).

1.Front plastic trim

2.Interior light

3.Thermostat knob

4.Adjustable glass shelves

5.Wine rack

6.Chiller compartment flap

7.Chiller compartment drawer

8.Salad Crisper

9.Air grille

10.Adjustable front feet

11.Door shelves

12.Egg tray

13.Bottle rack

14.Water dispenser tank

6

Page 4
Image 4
Beko TLDA 662 Front plastic trim 2. Interior light 3. Thermostat knob, Adjustable front feet 11. Door shelves 12. Egg tray