6Quick instructions for daily use
Preparation
1.Turn the tap on completely. Check if the hoses are connected tightly.
2.Place the laundry in the machine.
3.Add detergent and softener.
Starting
1.Press the “On/Off” button.
2.Select the programme and the temperature.
3.If required (according to your machine’s model):
–select any auxiliary function,
–adjust the spin speed,
–set the time delay,
4.Close the loading door.
5.Press “Start/Pause/Cancel” button.
Canceling a program
•Press “Start/Pause/Cancel” button for 3 seconds. At the end of this time, “Start/Pause/Cancel” light and all lights go off and “Spin” lamp illuminates. If the door is unlocked, all lights on the indicator will go off and the “Ready” lamp will light. You can select and start a new program when “Ready” light illuminates.
•The machine can drain all the water or can take in water for 3 times at most to cool down the clothes and complete the draining process. Also the “Spin” light illuminates if the cancellation process is activated in the middle of the program.
The “Spin” light goes off when discharging process is completed. The door can be opened and a new program can be selected when the
“Ready” lamp illuminates.
Adding more laundry
•This is only possible under the following conditions:
–during time delay,
CYou may add or remove laundry during the time delay (until the program starts).
–At the beginning of a washing cycle,
CMachine allows adding more laundry during a later step only if the water level is low enough to open the loading door or if the temperature in the machine is low enough.
In order to add laundry after the
1.Press “Start/Pause/Cancel” button.
Wait until the door is allowed to open. When the “Ready” lamp is on continuously, continue to the next step.
2.Open the loading door and put in more laundry.
3.Close the loading door.
4.Press “Start/Pause/Cancel” button.
Program is in rinse hold mode
CClothes may be left to soak in the machine as long as desired after filling during the last rinse step.
When it reaches this position while the machine is running, the “Start/
Pause/Cancel” light will flash.
If you wish to spin when the machine is in this mode:
Press “Start/Pause/Cancel” button. Program resumes. Your machine drains the water and spins your laundry.
If you want to discharge the water without spinning:
•Press “Start/Pause/Cancel” button.
The program continues and only drains the water.
Re-spinning the laundry
The control system for an unbalanced load can pause the spinning in cases when the distribution of the laundry in the drum is not balanced.
If you want to
1.Rearrange the previously placed clothes in machine.
2.Select the spin program.
3.Set the spin speed if spin speed adjustment is available on your machine.
4.Press “Start/Pause/Cancel” button.
22
EN
