hose falls out of its housing during water discharging.

The hose should be attached to a height of at least 40 cm, and 100 cm at most.

In case the hose is elevated after laying it on the floor level or close to the ground (less than

40 cm above the ground), water discharge becomes more difficult and the laundry may come out wet. Therefore, the heights described in the figure should be followed.

To prevent dirty water refilling the machine, and to allow for easy discharge, the end of the hose must not be submerged in the drain water. The end of the hose must be able to take in air. The hose should be pushed into the drainage for more than 15 cm. If it is too long you may have it shortened.

The end of the hose should not be bent, it should not be stepped on and it must not be folded between the drain and the machine.

The length of the hose is too short, you may add an extension hose to the original section. The length of the hose must not be longer than 3.2 m after coming out of the machine. To avoid water leakage failures, the connection between the extension hose and the drain hose of the product must be fitted well with an appropriate clamp as not to come off and leak.

Electrical connection

Connect the machine to an earthed outlet protected by a fuse of suitable capacity.

Important:

Connection should comply with national regulations.

Power cord plug must be within easy reach after installation.

The voltage and the allowed fuse protection are specified in the section “Technical Specifications”.

The specified voltage must be equal to your mains voltage.

Connection via extension cords or multi-plugs should not be made.

BA damaged power cable must be replaced by a qualified electrician.

BThe appliance must not be operated whilst faulty until it as been repaired! There is the risk of electric shock!

Destroying the packaging material

Packaging material can be dangerous to children. Keep the packaging materials out of reach of children or dispose them by classifying according to waste directives. Do not dispose of them together with normal domestic waste. Packaging materials of your machine are manufactured from recyclable materials.

Disposing of the old machine

Dispose of your old appliance in an environmental friendly manner.

You may refer to your local agent or solid waste collection center in your municipality to learn how to dispose of your machine.

Before disposing of your old washing machine, cut off the mains plug and make the door lock unusable.

11

EN

Page 11
Image 11
Beko WM 5140 S, WM 5140 W manual Destroying the packaging material, Disposing of the old machine