TAPE – On both the remote and the front panel, the TAPE button will cycle through the inputs, selecting the input to be routed to the Tape Out. If 7.1 Surround is not selected in Configuration Inputs, the two Surround Back (SB) (both XLR and RCA) channels will automatically be configured as Zone 2 and routed along with the Tape Output selection (for further explanation on ZONE2, please see page 10).
NOTE: Tape Out and ZONE2 route the same input.
When the tape input of a tape deck is connected to the tape output of the PRe6, you may record any selected source (CD, Phono, Tuner, etc) except the TAPE input. When the tape out- put of a tape deck is connected to the TAPE IN of the PRe6 you may moni- tor your recording.
Standby - When in standby mode the red LED is engaged and audio output is hard muted. Most internal circuitry is active while muting the output and turning off the display and controls.
Back Panel Configuration
© 2002 bel canto design, Ltd. | page 7 | PRe6 User’s Guide rev082102 |
