Balance Right - (available from the remote only) Shifts balance right in 0.5dB increments and reduces the volume in the opposite channel equally. Balance level is visible on the right side of the display.
MUTE - When coming out of Standby the PRe6 starts in Soft Mute. This volume level can be adjusted in Configuration (of) Inputs. (This Soft mute level is shown as the number of decibels below the current listen- ing level.) Pressing MUTE will first soft mute the unit. The volume quick- ly ramps down to the preset soft mute level and “SOFT” appears on the right side of the display. The vol- ume can be lowered while in soft mute and then taken out of soft mute at the desired listening level. After 3 seconds from pressing MUTE (after the display dims), pressing MUTE again will bring the PRe6 out of Soft mute. Pressing MUTE twice within 3 seconds (before the display dims) will fully mute the unit. The volume quickly ramps down and “MUTE”
appears on the right side of the dis- play. The listening level can again be lowered while muted and then taken out of mute at the desired level. Mute shuts off the audio output. Coming out of either mute mode, the volume quickly ramps back up to the dis- played level.
MAIN – Cycles through inputs. On the remote, this is accomplished with the LOOP button
INPUT – On the remote, the input buttons allow you to select between the 1st five active inputs. From the remote, you can cycle through inputs using the LOOP button. From the front panel, you can cycle through inputs by pressing the MAIN button. When switching between inputs, the PRe6 will quickly ramp down the vol- ume, switch inputs, then quickly ramp back up to the programmed volume setting. All inputs can be dis- abled if not used. See CONFIGURA- TION INPUTS section.
PRESS ENTER 4 TIMES OR HOLD FOR 2 SECONDS | VOLUME CONTROL* | SELECT TAPE INPUT* | |
TO ACCESS INPUT CONFIGURATION MODE |
|
|
|
|
|
| |
|
|
|
|
SOFT AND FULL MUTE FUNC- | INPUT SELECTION* | HARD MUTES OUTPUT, DISABLES DIS- |
TIONS |
| PLAY AND CONTROLS |
*ALSO USED FOR NAVIGATION WHEN IN INPUT CONFIGURATION MODE
© 2002 bel canto design, Ltd. | page 6 | PRe6 User’s Guide rev082102 |
