Bel Canto Design PRe6 Setup and Options, Modifying Factory Configuration, Top Level Menu

PRe6 Setup and Options

Factory Configuration:

The PRe6 has the following factory input settings:

Input 1: 5.1 Surround

Input 4, 5 and 6: Stereo

Input 7: 5.1 Surround

Input 10: Stereo

Input 11: Stereo

TAPE: Stereo

Modifying Factory Configuration:

Press the ENTER button on the remote eight times or press and hold the ENTER button on the front panel for two seconds to engage Configuration Mode.

Configuration Mode allows you to customize individual inputs/channels. Navigation is accomplished with the UP and DOWN and down arrow but- ton to select menu options, and the RIGHT and LEFT arrow buttons to select the input you wish to change (See pages 10-14). If you are called away for more than 30 seconds while in Input Configuration mode, the unit will exit Input Configuration mode. Your changes will remain in memory (but won’t take affect) until either the unit is shut off (deleting the changes) or you reenter Input Configuration mode and finish your adjustments, then SAVE (see below).

Top Level Menu

The Top Level menu screen has four options selectable using the right/left

arrow buttons: CONFIGURATION (of) INPUTS, CONFIGURATION (of) OFF- SETS, SAVE CONFIG? and ERASE CONFIG?.

CONFIGURATION (of) INPUTS:

Using the down arrow button, CON- FIGURATION (of) INPUTS menu allows you to customize your PRe6 in the following ways: Define Input (5.1, 7.1, Stereo, Disable), Name Input, Set MAIN Volume, Set SoftMute Vol(ume), Set Zone2 Volume. Press ENTER to edit a given setting, adjust setting using the UP and DOWN arrow buttons and press ENTER again to exit edit mode.

CONFIGURATION (of) OFFSETS:

The CONFIGURATION OFFSETS menu allows for adjustment of the Surround Sound speaker levels. The RIGHT and LEFT arrow buttons allow you to select either Surround Input. As you press the down arrow button, selection options are: Center, LFE- Sub, Left Surround, Right Surround. If 7.1 Surround is enabled, Sur Left Back and Sur Right Back will also be available. Surround levels can be adjusted +10 to –20 dB in relation to the front main speakers. Press ENTER to edit a given setting, adjust setting using the UP and DOWN arrow buttons and press ENTER again to exit edit mode.

© 2002 bel canto design, Ltd. page 8 PRe6 User’s Guide rev082102