HP HyperFabric manual Configuration Information Example, On node a

Configuring HyperFabric

Information You Need

Configuration Information Example

For this example, we have added some “dummy” (that is, not valid) addresses to the components in Figure 4-1, Map for Configuration Information Example, below. The “dummy” addresses are used only to show the flow of the information provided as input to the clic_init command and SAM. Do not try to use these addresses in your configuration.

Figure 4-1 Map for Configuration Information Example

Ethernet LAN	S			Switch ID: sw_clic1
Switch ID: sw_clic0
IP address: 193.0.0.20		HF	HF	IP address: 193.0.0.21
Ethernet MAC address:				Ethernet MAC address:
		switch 0	switch 1	00:60:b0:d0:02:56
00:60:b0:d0:02:57
				IP multicast address:
IP multicast address:
				226.10.1.1
226.10.1.1
HF		HF	HF	HF
adapter 0		adapter 1	adapter 0	adapter 1
Adapter ID:		Adapter ID:	Adapter ID:	Adapter ID:
clic0		clic1
			clic0	clic1
IP address:		IP address:	IP address:	IP address:
192.0.0.1		192.0.8.3	192.0.0.2	192.0.8.4
subnet mask:		subnet mask:	subnet mask:	subnet mask:
255.255.255.0		node A	255.255.255.0	node A
		255.255.255.0		255.255.255.0
	node A		node B
		lan0	lan0
IP address: 193.0.0.10			IP address: 193.0.0.11
S

Using the configuration information in Figure 4-1above, the information you would specify when you run clic_init or SAM on each of the nodes is listed below. Note that this example is not an exact depiction of the prompts produced by clic_init nor the fields in SAM, but merely an example of the flow of information input. Also, remember that you should not try to use the “dummy” addresses in your actual configuration.

On node A:

1.How many HyperFabric adapters are installed on the node?

2.Do you want this node to interoperate with nodes running any HyperFabric 10.20 version or HyperFabric versions earlier than B.11.00.11 or B.11.11.01?

3.What is the IP address of the first adapter (clic0)? (192.0.0.1)

88 Chapter 4