Managing HyperFabric

Starting HyperFabric

The clic_start -?command can be issued to display the online help for clic_start, or look at the clic_start (1m) man page by issuing the man clic_start command.

If HyperFabric is already running, you will receive an informational (FYI) message telling you so. Your reaction to this message depends on the situation:

If you have simply forgotten (or did not know) that HyperFabric was already running, you do not have to do anything.

If you have changed the HyperFabric configuration with the clic_init command or SAM, you must stop HyperFabric (by running the clic_shutdown command or using SAM) and then start HyperFabric (by running the clic_start command or using SAM). See either “Using the clic_shutdown Command” on page 99 or “Using SAM—HP-UX 11.0 and 11i 0nly” on page 100, whichever is appropriate.

 

 

Using SAM—HP-UX 11.0 and 11i 0nly

 

 

To use SAM to start HyperFabric on an HP 9000 system running HP-UX 11.0 or 11i,

 

 

follow these steps:

Step

1.

Start SAM.

Step

2.

Select the “Networking and Communications” area.

Step

3.

Select “HyperFabric.”

Step

4.

Pull down the “Actions” menu and select Start HyperFabric. Note that with a HP-UX

11.0operating system, if HyperFabric is already running, Start HyperFabric is grayed out and cannot be selected. With a HP-UX 11i operating system, if HyperFabric is already running, Start HyperFabric is not grayed out. With HP-UX 11i the newly added adapter can be configured and started (using OLA), without doing a clic_shutdown or a clic_start on the node.

When HyperFabric starts, a confirmation message displays. Also, the status

“HyperFabric: Running” is displayed above the adapter configuration area of the screen.

Step 5. Exit SAM.

86

Chapter 4

Page 110
Image 110
HP HyperFabric manual Using SAM-HP-UX 11.0 and 11i 0nly, Step