HP HyperFabric manual Example

Configuring HyperFabric

Information You Need

❏For each node in the fabric, you need the IP address of the node’s Ethernet LAN interface that is on the same subnet as the switches. (As mentioned earlier, a node might have multiple LAN interfaces.) Note that if you do not have switch management enabled, you do not need this information (clic_init will not prompt you for it).

As stated earlier, we recommend that you do not enable switch management.

IMPORTANT	You should also check your /etc/hosts file—when you are using files for host name look
	up—to ensure that the entries for all of the systems are in the correct format: the official
	host name, which is the full domain extended host name, and any alias names. For
	example:
	IP_address	bently6.corp3.com	bently6
	IP_address	bently4.corp7.com	test1
	IP_address	bently2.corp4.com	test3

Chapter 4 87