Configuring HyperFabric

Deconfiguring a HyperFabric Adapter with SAM—HP-UX 11.0 and 11i 0nly

 

 

Deconfiguring a HyperFabric Adapter with

 

 

SAM—HP-UX 11.0 and 11i 0nly

 

 

To use SAM to deconfigure a HyperFabric adapter on an HP 9000 system running

 

 

HP-UX 11.0 or 11i, follow these steps:

Step

1.

Start SAM.

Step

2.

Select the “Networking and Communications” area.

Step

3.

Select “HyperFabric.”

 

 

All HyperFabric adapters installed in the system are listed. Installed adapters that are

 

 

configured show Configured in the “Status” field, and installed adapters that are not

 

 

yet configured show Not Configured in the “Status” field. You can deconfigure only an

 

 

adapter with a status of Configured.

Step

4.

Highlight the adapter you want to deconfigure.

Step

5.

Pull down the “Actions” menu and select Deconfigure Adapter.

Step

6.

In the pop-up window, if you want to deconfigure the adapter, select OK to confirm it.

 

 

If you do not want to deconfigure the adapter, select Cancel.

Step

7.

If you selected OK, the entry for the adapter is deleted from the HyperFabric

 

 

configuration files (/etc/rc.config.d/clic_global_conf and

 

 

/etc/rc.config.d/netconf).

 

 

If you selected Cancel, you remain in the main “HyperFabric Configuration” screen.

Step

8.

Exit SAM.

96

Chapter 4

Page 96
Image 96
HP manual Deconfiguring a HyperFabric Adapter with, SAM-HP-UX 11.0 and 11i 0nly