Installing HyperFabric
Installing HyperFabric Switches
Steps for Installing the HF1 Switch
This section contains information for installing a HF1 switch. As mentioned earlier, the HF1 switch must be mounted using the rail kit shipped with the switch.
Figure 3-2 below shows the locations of the ports, LEDs, and power cord inlet on the back of the HF1 switch.
Figure 3-2 Back of HF1 Switch
|
|
| Ethernet | Ethernet port | Power | |||||
|
|
| port |
| LED | LED | ||||
|
|
|
|
|
| |||||
|
| Switch port LEDs |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 | Ethernet | Power | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Switch ports
Label showing | AC Inlet for | |
Ethernet MAC | ||
power cord | ||
address and | ||
| ||
port LED |
| |
colors and |
| |
meanings |
|
When you install the HF1 switch, you will be putting the front of the switch at the front of the rack. The steps for installing the HF1 switch are as follows:
Step 1. Prepare the rack for rail and switch installation.
68 | Chapter 3 |
