Bulldog Plus Installation
Please note that the USB communication is not supported by Windows 95 and NT4.0.
Bulldog Plus Setup:
1.Turn off your computer.
2.Attach the electrical power cable from the computer to the UPS.
3.Attach the electrical power cable from the UPS to an AC power outlet.
4.Plug the communication cable into the UPS, then plug the other end of the cable into the communication port on your computer.
5.Start your computer.
6.Check the communication type of your UPS. If you select the USB option you must have connected the UPS to the computer and install the HID driver.
7.Place the Bulldog CD in your
8.During the installation, the following dialog gives you 3 options:
•Program File: Files contain Bulldog Service, Bulldog Monitor and this
•Audio Files: Some .wav files. These files will be played to notify you when power event occurs.
•SNMP Files: Bulldog Plus SNMP DLL file.
9.After finishing the installation, the setup process will create a Bulldog Plus association.
10.The Bulldog Plus software is comprised of two modules:
•An UPS Monitoring Module (Bulldog Service), which runs in the background as a Windows Service and communicates to the UPS.
•An User Interface Module (Bulldog Monitor), which enables you to control and configure Bulldog Plus through the drop down menus and dialog boxes. It also allows you to monitor the UPS through the Main Screen.
Uninstall: To remove Bulldog Plus from your hard disk.
Help: Bulldog Plus
Bulldog Monitor: User interface, used to monitor and configure your UPS.
Bulldog Status: Reflect the status of Bulldog Plus service program, the service is used to communicate with your UPS.
Belkin Components | 6 |
