Installation
H. Connect the Phone/Fax/Modem Lines
Connect a single phone/fax/modem line into the
NOTE: This connection is optional but highly recommended as phone/fax/modem lines often carry dangerous surges and spikes. The Unit works properly without a phone/fax/modem connection.
CAUTION: The phone/fax/modem protection feature could be rendered inoperable if
improperly installed. Make sure that the telephone line from the wall is plugged into the connector marked “IN”, and the device to be protected is plugged into the connector marked “OUT”.
I. Connect the USB (Universal Serial Port) Communication Port
A USB port is provided to relay the signal to support Windows. To fully utilize the Belkin Automatic Shutdown software, you will need to connect the Unit to your computer. Connect the USB cable to the Unit, then connect the other end to your computer’s USB port.
Battery–Replacement Procedure
Caution:
•The Unit contains a 12V
•Risk of energy hazard. Before replacing batteries, remove conductive jewelry such as chains, wristwatches, and rings. High energy through conductive materials could cause severe burns.
•Do not
•Carefully install the batteries in the Unit housing, ensuring proper polarity. Reverse polarity installation may cause damage.
•Do not dispose of batteries in a fire. The battery may explode.
•Do not open or mutilate batteries. Released material is harmful to the skin and eyes.
It may be toxic.
•Use the UPS Unit only to recharge the batteries. Charging under other conditions can cause the
battery to leak, overheat, burst, and/or catch fire.
• Properly dispose or recycle used batteries.
Replacement requires removing the battery cover plate on the back of the Unit. No tools are needed. To replace the batteries:
1.Press fastener to remove the battery cover plate on the back of the Unit.
2.Disconnect the insulated connectors from the battery terminals.
3.Remove the battery then insert a new battery pack, and push the connectors onto the battery terminals
NOTE: There may be a small spark at the battery terminals when reconnecting the connectors. This is normal and will not harm you or the Unit.
4.Close the battery cover.
Belkin Automatic Shutdown Software Installation
Software Installation (Optional)
A)To fully utilize the Battery Backup and its software, your computer must be able to operate the following operating systems:
Windows 98, Me, NT 4, 2000, 2003, or XP, and have a USB port.
B)Your Battery Backup features the Belkin Bulldog Plus Software. This protects and saves your data should a power outage
occur, and safely shuts down your computer in your absence. Please be sure to close all applications prior to installing the software.
1.To install the software, place the CD into your computer’s
2.Your computer should automatically run the installation from the CD. If it does not, click the “Start” icon on the lower, left- hand corner of your screen, and select
7
