P74042_F1DE108E_man.qxd 5/6/02 10:06 AM Page 14
I N STA L L AT I O N
Connect the Console
1.Set BANK address to zero. (The BANK address is preset to zero at the factory.)
2.Connect the monitor to the KVM Switch. Attach your monitor cable to the HDDB15 female port on the back of the KVM Switch labeled “Console”.
3.Connect the PS/2 or USB keyboard to the appropriate port on the back of the KVM Switch in the “Console” section.
4.Connect the PS/2 or USB mouse to the appropriate port on the back of the KVM Switch in the “Console” section.
5.Attach the IEC power cable to the power connector located on the rear of the KVM Switch. Power on the KVM Switch.
6.Boot up all of your host servers.
Console connection
I N STA L L AT I O N
MULTIPLE KVM SWITCHES—INSTALLATION (DAISY-CHAINING)
You can
Note: An ENTERPRISE Series
All ENTERPRISE Series KVM Switches feature a “BANK DIP” Switch. The BANK DIP Switch is used for proper identification of the KVM Switch, either in a standalone or multiunit configuration.
•For a
•For multiunit configuration, the BANK DIP Switch on the Primary Switches must be set to BANK address 00 to 03. Secondary Switches must be set to a unique BANK address (from 00 through 15). Refer to the chart on the next page for DIP Switch settings.
14 | 15 |