device is connected. For example, we have a scanner and a printer on the Bitronics switch:
You will be connected to the scanner device indefinitely. But lets say you wish to print to the Ink Jet printer, the software will again automatically switch to the port that has the printer and send the print job. However, the switch will remain connected to the printer - it will not change back to the Scanner, unlike the mass storage device mentioned previously. This means that you have to use this method to switch to the scanner each time you need to use it.
If no printers are installed
If no printers are installed, the SETTINGS type (see step 7) for each device must be set either for MASS STORAGE DEVICE (if the device adds a drive letter to your system), or SCANNER (for all other types of devices).
The Bitronics software may not function properly in some systems if there is no DEFAULT PRINTER set. To do this, add a printer using the Add Printer Wizard (click START, SETTINGS, PRINTERS), and just use the “Generic / Text Only” driver. Remember to use “Local Printer” and “LPT1” when the wizard asks you. This will then be set as your default printer, so that the Bitronics software can work properly.
Removing and Adding the Bitronics Switch Icon from the System Tray
•To remove the icon, simply right click on it, and answer YES to the prompt.
•To reload the icon back into the system tray, click on START, PROGRAMS, BELKIN BITRONICS SWITCH,
Using the File Transfer Feature
The file transfer feature of the Bitronics switch allows both computers to connect as if there was a file transfer cable connected between them. To do this,
FILE TRANSFER:
A set of PC LEDs on the Bitronics switch will turn green. These LEDs represents the computer you are on now is set for file transfer mode.
Next, the second PC must also perform the same operation. When both sets of PC LEDs on the Bitronics switch are green (all four),
then the computers are ready for file transfer. At this point, the cables and the Bitronics
15
