Moving the Fryer
If you ever want to move the fryer to a different workstation, follow this procedure:
1.Turn off the fryer and disconnect it from the power source.
2.Allow the machine and the shortening to cool.
WARNING
Do not touch hot shortening. It can cause
serious burns.
3.Remove the shortening from the fryer as explained in “Removing the Shortening” in Section 3.
WARNING
To avoid burns, falls, other injury, or death, never attempt to move the fryer when it has shortening or other liquid in it.
WARNING
Thoroughly clean and dry the floor if
shortening is spilled. Materials on the floor can cause people to slip or fall, resulting in serious injury or loss of life.
4.Remove the bolts that secure the fryer to the floor.
5.Using a fork lift, transport the machine to the new workstation.
6.Level the fryer, bolt it to the floor, and connect it to the power source, as explained in “Installing the Fryer” above.
Mounting the Drain Tray
If you ever want to mount the drain tray on the opposite side of the fryer, follow the steps below. You cannot move the drain tray if your fryer has a Belshaw Shortening Melter (FM) mounted on it.
1.Remove the two acorn nuts on the ends of the drain tray hinge shaft.
2.Slide the drain tray hinge shaft out of the drain tray mount brackets.
3.Lift off the drain tray.
4.Remove the bolts and washers that hold the drain tray mount brackets in place. Remove the mount brackets.
5.Tilt the heater head back and lock it in place.
6.Loosen the set screws in the drain valve extension knob on the side of the cabinet. Remove the knob.
7.Inside the cabinet, there is a set collar on the drain valve extension rod. Loosen the set screw in the set collar. Slide the set collar toward the drain valve. Remove the extension rod and the bushing.
8.Remove the hole plug from the hole in the opposite side of the cabinet and insert the bushing in its place. Install the hole plug in the hole where the bushing was.
9.Remove the kettle from the cabinet, turn it 180º, and put it back in the cabinet.
10.Install the extension rod and the drain valve extension knob at the new location. To do this, reverse the procedure outlined in steps 6 and 7.
11.Remove the two drain tray support rests that are mounted on the outside of the cabinet. Each support rest is held in place by two
12.Install the drain tray support rests on the opposite side of the cabinet.
Belshaw Bros., Inc. 1750 22nd Ave. S. Seattle, WA 98144 Phone
2 | 618L, 624, and 634 Electric Fryers |
